The first mistake I often see is not setting up the scooter properly
On the Internet, you can often see some videos or pictures of the falling of the scooter posted by others. The screws are off and the cockpit screws are not tightened. Therefore, before riding the scooter, please make sure that the scooter is ready for riding.
After unpacking the scooter, tighten all the screws and bolts on the scooter. On the packing list, please pay attention to the corresponding load or bolt type. Never believe products with improper or improper installation of parts.
A new scooter needs to adjust your cockpit, which includes the controller, step on the brakes that have been set, and other buttons and joysticks. Your cockpit should be adjusted to the most comfortable.
Tips for adjusting your scooter:
- Loosen all items on the handlebar, including brakes, car bells, etc.
- Keep the scooter upright against the wall, and keep it stable and safe when you ride it.
- Keep your hands on the handlebar in a comfortable and natural position, sliding and rotating the brake system, it is recommended to fix the brake device close to the hand.
- Don’t pinch your fingers with the bell.
- Slide the brake lever inward and the handlebar can give you greater leverage.
- Re-tighten the bolts to ensure that they are sufficiently tightened. At the same time, avoid over-tightening. Over-tightening may cause damage to the parts. Just tighten them firmly enough.
